Skip to content
Wopiqe Request a visit

Pipe repairs and fixture replacement

Water pipes rarely fail without warning. A damp patch under a sink, a joint that weeps, a tap that will not close fully — each of these is a small repair today or a larger one later. Wopiqe handles pipe and fixture work in a plain, methodical way: find the cause, fix it properly, and leave the installation dry and tidy.

Repairs cover supply pipes, drain connections, shut-off valves, taps, and traps. Every job is approached the same way: isolate the water, diagnose the actual fault, replace only what needs replacing, and test the result before leaving. Details of each case are confirmed on request.

Request a visit
Wall-mounted sink faucet being checked for leaks

What the repair work covers

The scope below describes the work in general terms. What your specific situation needs is assessed before anything is taken apart.

  1. Leaking joints and pipe sections

    Compression, push-fit and soldered connections are inspected, tightened or rebuilt as needed. Damaged pipe sections are cut out and replaced with matching material, and the whole run is pressure-checked afterwards.

  2. Tap and mixer replacement

    Worn taps, mixers and shower valves are swapped for new fixtures supplied by you or ordered to fit the existing connections. Isolation valves are checked so future maintenance stays simple.

  3. Sink, trap and drain connections

    Bottle traps, siphons and waste outlets are resealed or renewed, and the drain connection under the fixture is tested with a full flow of water. For deeper blockages in the pipework itself, see drain clearing.

  4. Shut-off valves and supply lines

    Stuck or weeping angle valves, flexible hoses and toilet supply lines are replaced so every fixture can be isolated independently — a small detail that makes any later repair far easier.

Guarantees and responsibility

Work is carried out with materials appropriate to the installation, and every repair is tested before the site is left. If something related to the completed work is not right, it is looked at again. How we handle the information you send us is described in the privacy policy.

How a repair visit runs

The same calm sequence applies to a dripping joint and to a full fixture swap.

Water off, cause found

The supply is isolated and the actual source of the problem is traced — a stain on a cabinet floor is not always the joint above it. The diagnosis is explained in plain language before work starts.

Repair with the right material

Only parts suited to the pipe system and water conditions are used. Threads are sealed properly, supports are checked, and nothing is left hand-tight that should be wrench-tight.

Tested and left clean

The repair is run under normal working pressure and watched for a while. The work area is wiped down, packaging is removed, and you are shown what was done. For urgent leaks that cannot wait, the emergency visit page explains how a call-out is arranged.